VCDQuality Forums - DVD Burning (playback)

Show all 7 posts from this thread on one page

VCDQuality Forums (http://www.vcdhq.com/forum/index.php)
- Jargon, Encoding/Conversion and Burning (http://www.vcdhq.com/forum/forumdisplay.php?forumid=9)
-- DVD Burning (playback) (http://www.vcdhq.com/forum/showthread.php?threadid=50574)

Posted by macca1969 on 11-16-2004 07:43 PM:

DVD Burning (playback)

I have burnt some dvd,s seem to play ok first couple of times then
they stop and start and pixelate i have been told that if i burn disk
at 1x this might sort problem out because the outer edge of some disk can be dodgy can anyone tell if this is the case or should i just buy expensive dvds

thanks for any advice

Posted by Neversoft on 11-16-2004 08:07 PM:

I hear people saying to burn at low speeds all the time and personally I've never had a problem burning at the speed the CD/DVD is rated at. It might be your choice of blank though, Datawrite Grey are cheap and decent, try those.

__________________
Statistically... 9 out of 10 people actually enjoy gang rape.

Posted by ComeT on 11-17-2004 12:42 AM:

I have recently had this exactly the same problem. I have asked a few forums & most of them say change your media to branded names... But this NOT always the case.... I bought these philips dvd-r 8x discs & burning at 8x screws up, so now I burn at x4 & it works a treat. I then bought these cheap ass ritek discs & they also work fine.... even at 8x burning.

What I suggest you do is to try different media, and someday you will find the one thats compatible with your burner.
Good luck m8

Posted by ComeT on 11-17-2004 12:46 AM:

By the way.... Go to the manufacturers site of ya burner & try updating your firmware... This helps ALOT !!!

Posted by J Fresh on 11-18-2004 05:11 AM:

hit up meritline and order the Ritek G04 4x DVD-R 25pack for like $15....but actually you get Ritek M02, which are still good for the price.

__________________

Posted by LOLobo on 11-18-2004 05:31 AM:

I swear by Meritline.com's ProDisc for about $19 for a 50 pack of hub inkjet printable.

Posted by Oglethorpe on 11-18-2004 07:14 AM:

quote:
Originally posted by Neversoft
I hear people saying to burn at low speeds all the time and personally I've never had a problem burning at the speed the CD/DVD is rated at.

I had heard this for a very long time before I believed it myself. I can make a fullspeed burned (40x) (S)VCD that will play on any computer, but my standalone player gets pissy on anything I burn over 16x.
Try any of these suggestions and you'll get some better results.

__________________
fuckinggoogleit.com
"The power of accurate observation is commonly called cynicism by those who have not got it."
-George Bernard Shaw
I like proof!

All times are GMT. The time now is 05:42 PM.

Show all 7 posts from this thread on one page